Sharp CD-BA2600 CDBA250|CDBA2600 Operation Manual - Page 23

Recording from the Radio Before recording: z When recording important selections, make a preliminary test to ensure that the desired material is properly recorded. z SHARP is not liable for damage or loss of your recording arising from malfunction of this unit. z The volume and sound controls can be adjusted with no effect on the recorded signal (Variable Sound Monitor). z For recording, use only normal tapes. Do not use metal or CrO tapes. Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback only. 1 Tune in to the desired station. (See page 20.) 2 Load a cassette into the TAPE 2 cassette compartment with the side to be recorded on facing you. Wind past the leader of the tape, on which recording cannot be performed. 3 Press the REC PAUSE ( ) button. Recording will be paused. 4 Press the / button on the main unit or the TAPE 2 the remote control to start recording. button on Tape Recording - Recording from the Radio - To interrupt recording: Press the REC PAUSE ( ) button. To resume recording, press the / (TAPE 2 ) button. To stop recording: Press the (TAPE ) button. Note: If you hear a whistling noise while recording an AM station, move the AM loop antenna. Erase-prevention tab of cassette tapes: z When recording on a cassette tape, make sure that the erase-prevention tabs are not re- moved. Cassettes have removable tabs that prevent accidental recording or erasing. Tab for side B z To protect the recorded sound, remove the tab after recording. Cover the tab hole with adhe- sive tape to record on the tape without the tab. Side A Tab for side A Listening to the Radio (See page 20.) 23 00/12/4 CD-BA250(U)3.fm