Sharp CD-BA2600 CDBA250|CDBA2600 Operation Manual - Page 24

Tape Recording - Recording from a CD (CDs) - Recording from a CD (CDs) 24 Programmed Play (See page 19.) You can record 3 CDs continuously. 1 Press the ON/STAND-BY button to turn the power on. 2 Load a cassette into the TAPE 2 cassette compartment with the side to be recorded on facing you. Wind past the leader of the tape, on which recording cannot be performed. 3 Press the CD button and load the desired disc. 4 Press one of the 1 - 3 buttons on the remote control to select the disc to be recorded first. 5 Press the REC PAUSE ( ) button. Recording will be paused. 6 Press the / (TAPE 2 ) button to start recording. z CD playback will start approximately 5 seconds after the tape starts. z Recording is started from the selected CD. When the playback of the last disc is finished or the end of the tape is reached, the CD and the cassette will stop automatically. To perform programmed recording: 1 Program discs and tracks. (See page 19.) 2 Press the REC PAUSE ( ) button. 3 Press the / (TAPE 2 ) button. To stop recording: Press the (CD ) button. The CD and tape will stop. Note: When the end of the tape is reached while recording, the CD player will display the track number which was being played at that time, and stop automatically. If you want to restart recording from the beginning of the interrupted track, turn over the tape, press the REC PAUSE ( ) button and then the / (TAPE 2 ) button. (If tracks have been stored in memory by programming, recording will restart from the first track stored in memory.) 00/12/4 CD-BA250(U)3.fm