Sharp CD-ES777 CD-ES777 Operation Manual - Page 11

SPEAKERS LIGHT-UP RIGHT LEFT Preparation for Use Antenna connection Supplied FM antenna: Connect the FM antenna wire to the FM 75 OHMS jack and position the FM antenna wire in the direction where the strongest signal can be received. FM antenna AM loop antenna Supplied AM loop antenna: Connect the AM loop antenna to the AM and GND terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf, etc., or attach it to a stand or a wall with screws (not supplied). Black ANTENNA FM GND White AM 75 OHMS Note: Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception. Installing the AM loop antenna: < Assembling > < Attaching to the wall > Wall Screws (not supplied) CD-ES777 Speaker connection Connect the black wire to the minus (-) terminal, and the red wire to the plus (+) terminal. Red AC INPUT Black Caution: Use speakers with an impedance of 6 ohms or more, as lower impedance speakers can damage the unit. Do not mistake the right and the left channels. The right speaker is the one on the right side when you face the unit. Do not let the bare speaker wires touch each other. Do not allow any objects to fall into or to be placed in the bass reflex ducts. Do not stand or sit on the speakers. You may be injured. Incorrect Speaker Light-Up Connection Connect the speaker light-up wires to the SPEAKERS LIGHT-UP jacks for speaker illumination. To turn off the speaker light-up feature, press the CLEAR/DIMMER button on the remote control for 2 seconds or more. LEFT SPEAKER RIGHT SPEAKER AC INPUT Note: Placing the right speaker light-up wire to the RIGHT jack and the left speaker light-up wire to the LEFT jack. 11