Sharp CD-SW300 CD-SW300 Operation Manual - Page 33
Recording from the radio, Dubbing from tape to tape, Erasing recorded tapes
View all Sharp CD-SW300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
CD-SW300 To perform programmed recording: 1 Program discs and tracks (see page 23). 2 Press the button. 3 Press the / (TAPE ) button to start recording. To stop recording: Press the (TAPE ) button. The disc and tape will stop. Recording from the radio 1 Tune in to the desired station (see page 28). 2 Load a cassette into the TAPE 2 cassette compartment with the side to be recorded on facing you. Wind past the leader of the tape, on which recording cannot be performed. 3 Press the button. Recording will be paused. Dubbing from tape to tape You can record from TAPE 1 to TAPE 2. 1 Press the ON/STAND-BY button to turn the power on. 2 Load a prerecorded cassette into the TAPE 1 cassette compartment. Insert a blank tape into the TAPE 2 cassette compartment. TAPE 1 TAPE 2 It is recommended that the recording tape is the same length as the master tape. 3 Press the TAPE (1 2) button until "TAPE 1" appears on the display. 4 Press the button. Recording will be paused. Tape Recording 4 Press the / (TAPE ) button to start recording. 5 Press the / (TAPE ) button to start dubbing. To interrupt recording: Press the button. To resume recording, press the / (TAPE ) button. To stop dubbing: Press the (TAPE ) button. TAPE 1 and TAPE 2 will stop simultaneously. To stop recording: Press the (TAPE ) button. Note: If you hear a whistling noise while recording an AM station, move the AM loop antenna. Erasing recorded tapes 1 Load the tape to be erased into the TAPE 2 cassette compartment with the side to be erased facing toward you. 2 Press the TAPE (1 2) button until "TAPE 2" appears on the display. 3 Press the button. 4 Press the / (TAPE ) button to start erasing. Note: Make sure that the TAPE 1 is not in use. 33