Sharp CDG14000 CD-G14000 Operation Manual - Page 12

Preparation for Use RATED SPEAKER IMPEDANCE : 6 OHMS MIN. CD-G14000 System connections (continued) Antenna connection Supplied FM antenna: Connect the FM antenna wire to the FM 75 OHMS jack and position the FM antenna wire in the direction where the strongest signal can be received. FM antenna AM loop antenna Supplied AM loop antenna: Connect the AM loop antenna to the AM and GND terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf, etc., or attach it to a stand or a wall with screws (not supplied). ANTENNA FM GND AM 75 OHMS Note: Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception. Installing the AM loop antenna: < Assembling > < Attaching to the wall > Wall Screws (not supplied) Speaker connection Front speakers: Connect the black wire to the FRONT SPEAKERS (-) terminal, and the red wire to the FRONT SPEAKERS (+) terminal. Front speaker (right) Front speaker (left) Front speaker (right) Front speaker (left) Red Black Caution: Connect the speaker wires to the speakers first, then to the unit. If you use other speakers with impedance lower than that specified, the unit may be damaged. Front speakers: 6 ohms Do not mistake the right and the left channels. The right speaker is the one on the right side when you face the unit. Do not let the bare speaker wires touch each other. Incorrect Do not allow any objects to fall into or to be placed in the bass reflex ducts. Do not stand or sit on the speakers. You may be injured. Incorrect 12