Sharp CDG14000 CD-G14000 Operation Manual - Page 41
Troubleshooting chart
UPC - 074000368941
View all Sharp CDG14000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Headphones Before plugging in or unplugging the headphones, reduce the volume. Be sure your headphones have a 1/8" (3.5 mm) diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms. Plugging in the headphones disconnects the speakers automatically. Adjust the volume using the VOLUME control. 5 4 3 2 1 TIMER POWER ON/ STAND-BY CD TAPE (1 2) TUNER (BAND) AUDIO IN PRESET TUNING VOL. REMOTE SENSOR c OPEN/ CLOSE 5 4 3 PRESET 2 1 VOL. TUNING Troubleshooting chart CD-G14000 Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center. General Symptom The clock is not set to the correct time. When a button is pressed, the unit does not respond. No sound is heard. Possible cause Did a power failure occur? Reset the clock. (Refer to page 19.) Set the unit to the power stand-by mode and then turn it back on. If the unit still malfunctions, reset it. (Refer to page 43.) Is the volume level set to "0"? Are the headphones connected? Are the speaker wires disconnected? References PLAYBACK (PLAY & STOP) PHONES AUDIO IN RECORD/PLAYBACK CD player Symptom Playback does not start. Playback stops in the middle or is not performed properly. Playback sounds are skipped, or stopped in the middle of a track. Possible cause Is the disc loaded upside down? Does the disc satisfy the standards? Is the disc distorted or scratched? Is the unit located near excessive vibrations? Is the disc very dirty? Has condensation formed inside the unit? 41