Sharp CDG14000 CD-G14000 Operation Manual - Page 17

Subwoofer control

Get Sharp CDG14000 PDF manuals and user guides
UPC - 074000368941
View all Sharp CDG14000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Subwoofer control CD-G14000 Before you turn the system on/off on the main unit, minimize the speaker volume on the main unit and turn the VOLUME control of the subwoofer to "-". Subwoofer light up The subwoofer unit surface will light up and blink according to BASS SOUND LEVEL. During STAND-BY MODE (demo mode): When subwoofer is turned ON, the subwoofer unit will emit blinking light. During STAND-BY MODE (low power consumption mode): When subwoofer is turned ON, no light will be emitted from the subwoofer unit. Notes: Observe the following to avoid malfunction and sound distortion. Do not set the volume too high on the main unit. The subwoofer may be damaged. Before you switch on/off on the main unit, minimize the volume on the main unit. Unplug the AC power cord when connecting the subwoofer cable. Preparation for Use Power switch Press the POWER ON/OFF button to turn ON the Active subwoofer. Volume control Turn the VOLUME control clockwise to increase the volume, and turn it counterclockwise to decrease the volume. Crossover frequency control Adjust the high frequency cut-off point. Frequencies higher than the set frequency are removed. To emphasize the bass, turn this control toward 35 Hz and increase the volume. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
CD-G14000
17
Preparation for Use
Subwoofer control
±
Power switch
Press the POWER ON/OFF button to turn ON the Active subwoofer.
±
Volume control
Turn the VOLUME control clockwise to increase the volume, and turn
it counterclockwise to decrease the volume.
±
Crossover frequency control
Adjust the high frequency cut-off point. Frequencies higher than the
set frequency are removed.
To emphasize the bass, turn this control toward 35 Hz and increase
the volume.
±
Subwoofer light up
The subwoofer unit surface will light up and blink according to BASS
SOUND LEVEL.
During STAND-BY MODE (demo mode):
When subwoofer is turned ON, the subwoofer unit will emit blinking
light.
During STAND-BY MODE (low power consumption mode):
When subwoofer is turned ON, no light will be emitted from the
subwoofer unit.
Notes:
Observe the following to avoid malfunction and sound distortion.
²
Do not set the volume too high on the main unit. The subwoofer
may be damaged.
²
Before you switch on/off on the main unit, minimize the volume on
the main unit.
²
Unplug the AC power cord when connecting the subwoofer cable.
Before you turn the system on/off on the main unit, minimize the
speaker volume on the main unit and turn the VOLUME control of
the subwoofer to “–”.