Sharp DV-SL90UA Service Manual - Page 18
FLOW CHART NO.7, Check D1008, C1007, C1038, L1007 and
![]() |
View all Sharp DV-SL90UA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
FLOW CHART NO.6 P-ON+10V (EV+11V) is not outputted. Is 11V voltage supplied to the emitter of Q1002? No Yes Is the voltage of base on Q1002 lower than the No voltage of emitter on Q1002 when turning the power on? Yes Replace Q1002. Check D1030, D1048, C1035, C1048, L1009 and the periphery circuit, and service it if defective. Check Q1016 and PWRCON line and service it if defective. FLOW CHART NO.7 P-ON+5V is not outputted. (EV+11V is outputted normally.) Is the "H" signal inputted into the base of Q1004? No Yes Replace Q1004. Check R1068 and D1046, and service it if defective. FLOW CHART NO.8 P-ON+3.3V is not outputted. (P-ON+10 V is outputted normally.) Is 3.3V voltage supplied to the collector of Q1011? No Yes Replace Q1011 or R1067. Check D1008, C1007, C1038, L1007 and the periphery circuit, and service it if defective. FLOW CHART NO.9 EV+5V is not outputted. Is EV+11V outputted normally? Yes Check D1047 and the periphery circuit, and service it if defective. No Refer to "FLOW CHART NO.6" FLOW CHART NO.10 EV+1.2V is not outputted. Is 2.5V voltage supplied to Pin(1) of IC1002? No Check D1006, C1014, L1008 and the periphery circuit, and service it if defective. Yes Replace IC1002. 1-8-3 E592BTS
![](/manual_guide/products/sharp-dvsl90ua-service-manual-a6a376f/18.png)