Sharp HN-VA401SU HNVA401SU Operation Manual - Page 13

Registering an Additional Adapter Registering an Additional Adapter If you purchase an additional adapter, follow the steps below to register the adapter. The new adapter cannot be used until it is registered. ♦Up to 16 adapters can be used on one network. 1 Plug the new adapter into an outlet next to one of the existing adapters. • Check the PLC indicator on the existing adapter and make sure it is solidly lit or blinking (registration is not possible if the existing adapter is not able to communicate normally on the network). Existing adapter New adapter 2 Hold down the SET button on the existing adapter for about 2 seconds and then release it. • When you release the SET button, the POWER indicator will blink. • Do not hold the SET button down too long (if it is held down for about 10 seconds, the registration will be cleared). SET POWER 11