Sharp HN-VA401SU HNVA401SU Operation Manual - Page 14
Registering an Additional Adapter, POWER, Important
![]() |
View all Sharp HN-VA401SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Registering an Additional Adapter 3 Hold down the SET button on the new adapter for about 2 seconds and then release it (this must be done within 2 minutes of completing Step 2). • When you release the SET button, the POWER indicator will blink and registration will begin. During registration, communication on the network may stop temporarily. Registration may take up to 30 seconds. • Important: Do not remove either adapter from the outlet while registration is taking place. SET POWER 4 When registration is completed, the POWER indicator on both adapters will stop blinking and the PLC indicator on both adapters will light solidly or blink. Remove the new adapter from the outlet and plug it into the outlet where you wish to use it. • If the PLC indicator on the new adapter does not light up and instead the POWER indicator blinks in the pattern 2 blinks OFF 2 blinks OFF ... registration was not successful. Cancel the registration of the adapter as explained on page 18, and then try registration again. 12
![](/manual_guide/products/sharp-hnva401su-hnva401su-operation-manual-b6a797c/14.png)