Sharp KC-C100U KC-C100U Operation Manual - Page 19

ENGLISH FRANÇAIS HUMIDIFYING TRAY Care Cycle 1 month Frequency of maintenance cycle will depend on the hardness of the water. Avoid spilling water when removing or cleaning the tray. 1 Remove the Water Tank and Humidifying Tray. Unlatch the Wa- ter Tank first, then remove the tray. Tank Handle Use both hands when pulling out the Humidifying Tray to Water Tank avoid spilling water. 2 Remove the Water Tank and Humidifying Filter from the Humidifying Tray. Drain accumulated water by tilting the Humidifying Tray slowly. When Water Deposits are Difficult to Remove 1 Fill Humidifying Tray halfway with lukewarm water, add a small amount of mild kitchen detergent, and leave to soak for about 30 minutes. Dilute detergent according to instructions on the container. Clean difficult-to-reach parts with a cotton swab or tooth brush. Humidifying Filter Do not hold this part. Humidifying Tray 3 Rinse the inside of the Humidifying Tray with lukewarm water to remove impurities. • Do not remove the Styrofoam float . • Clean difficult-toreach parts with a cotton-tipped swab or tooth brush. Float 2 Rinse the Humidifying Tray with lukewarm water. • Rinse until all detergent residue is removed. • Inadequate rinsing may cause the detergent odor or changes in the shape/ color of the main unit. 4 Replace the Humidifying Filter and replace the Humidifying Tray in the unit. The Humidifying Filter will not fit if placed in backwards. Be sure there is no gap between the Humidifying tray and the unit when the Humidifying Tray is replaced in the unit. The unit may not operate properly if the Humidifying Tray is not properly replaced in the unit. Color:Gray CAUTION • Use only mild kitchen detergents to clean the Humidifying Tray. Use of non-designated chemicals or detergents can cause deformation, tarnishing, cracking (water leakage). ESPAÑOL If the Styrofoam float comes off, replace by inserting the tabs of the Float into the holes in the Humidifying Tray as shown in the diagram. Insert the tab of the float into the hole. E-17 Insert the float below this tab. Insert the tab on the other side of the float into the hole.