Sharp LL172AB Operation Manual - Page 16

Connecting the monitor and turning the monitor on and off When connecting using a separately sold 2-input cable [LL-172G] The separately sold 2-input cable (model name: NL-C03J) enables connection between the DVI-I input terminal on the monitor and the two computers. (One analog and one digital connection.) 1. Connect the 2-input cable to the DVI-I input terminal of the monitor. DVI-I input terminal (INPUT-2) Notes: - When using the 2-input cable, set the connecting input terminal [INPUT-2] to [2LINES] under the MODE SELECT-2 Menu. (p.24) - The monitor connected to the 2-input cable by analog connection may not be automatically recognized and setup under Plug & Play. Perform storage of setup information manually. (p.31) Connect the accessory audio cable When the accessory audio cable is connected to the audio output terminal of the computer, the sound of the connected computer is output from the monitor speakers. You can also use the headphone jack of the display. Mini D-sub 15 pin Audio input terminal 2-input cable (purchased separately) DVI-D 24 pin 2. Connect the accessory or commercially available analog signal cable and the accessory digital signal cable to the 2-input cable. - When using commercially available analog signal cable, both ends should be mini D-sub 15 pin. 3. Connect each signal cable to the computers. Audio output terminal Audio cable Analog signal cable Analog RGB output terminal Digital signal cable Digital RGB output terminal - Paying attention to connector direction, firmly insert the signal cable into the connector, and then tighten the screws at both sides. 16