Sharp MX-4071 User Manual FAQ - Color Advanced & Essential Series 2 - Page 15

General Problems Check ! Solution Is the paper size specified? Did you add paper to the bypass tray? Are you using punched paper? Are you using label sheets that cannot be used? Remove the paper, turn it over, and reload it. Using a different paper type may solve the problem. Did you load an envelope? ■ If you are using a non-standard size, be sure to specify the paper size. If the size of paper loaded into a tray was changed, be sure to check the paper size setting.  "Settings" → [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Tray Registration] ■ When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and reload as a single stack. If paper is added without removing the remaining paper, a misfeed may occur. ■ When using punched paper, set the paper type to punched.  "Settings" → [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Tray Registration] ■ Labels without a carrier sheet may stick to the transfer surface and cause a misfeed. ■ This may improve some states of paper curling. ► Placing the original and adding paper (page 5) ■ Do not load envelopes except tray1 and the bypass tray. ■ When loading envelopes in tray 1, do not exceed the indicator line. ■ Set the paper type to "Envelope", and for the paper size, specify the paper size you set. ? PAPER DOES NOT FEED FROM THE PAPER TRAY Check Is the paper loaded correctly into the paper tray? Has the tray been prohibited in some modes (copy, print, fax, image send, document filing)? ! Solution ■ Set the guides to the size of the paper. Reload the paper. Load no more than the maximum number of sheets and do not exceed the indicator line. ► Placing the original and adding paper (page 5) ■ Check the settings in [Paper Tray Settings] and see if checkmarks appear in the checkboxes of each mode ([Feeding Approved Job]). Functions without a checkmark cannot be used for printing using that tray.  "Settings" → [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job] ? I DON'T KNOW HOW TO CHANGE THE PAPER SIZE Check ! Solution Set the paper size used in each tray in the tray settings. ■ The "Tray Settings" key can be found in the home screen. Tap this key to display the tray settings screen. Tap the tray whose paper size you want to change, select the paper type, and then tap the [Size] tab. Select the paper size and tap the [OK] key. If you loaded a special size of paper in the bypass tray, tap the [Direct Entry] key after tapping the [Size] tab, enter the paper size manually, and tap the [Execute] key. 15