Sharp MX-M264N Operation Guide - Page 196

COPIER ADDING A WATERMARK TO A COPY (Watermark) This function requires the hard disk drive. When making a copy, specific text can be added to the copy as a watermark. The density, angle, and pages (first page only or all pages) can be selected for a watermark. The watermark is printed at the centre of the paper. Printing "CONFIDENTIAL" on the paper CONFIDENTIAL The following 12 selections are available for the stamp text. CONFIDENTIAL PRIORITY PRELIMINARY FOR YOUR INFO. DO NOT COPY IMPORTANT URGENT DRAFT TOP SECRET FINAL COPY PLEASE REPLY Three levels can be selected for the density of the watermark. The angle of a watermark can be selected in the range +90 degrees to -90 degrees in increments of 45 degrees. 1 Touch the [Watermark] key in the stamp selection screen. See steps 1 to 4 of "GENERAL PROCEDURE FOR USING STAMP" (page 2-81). 2 Stamp Watermark CONFIDENTIAL FOR YOUR INFO. URGENT PRELIMINARY IMPORTANT TOP SECRET PRIORITY DO NOT COPY DRAFT FINAL COPY PLEASE REPLY Cancel Exposure 1 23 Angle (+90 -90) 45 OK First Page All Pages Touch the key of the watermark that you wish to use. 3 Stamp Watermark CONFIDENTIAL FOR YOUR INFO. URGENT PRELIMINARY IMPORTANT TOP SECRET PRIORITY DO NOT COPY DRAFT FINAL COPY PLEASE REPLY Cancel Exposure 1 23 Angle (+90 -90) 45 OK First Page All Pages Touch the [Exposure] key and set the colour and density. If you wish to darken the exposure, touch the key. If you wish to lighten the exposure, touch the key. When you have finished selecting the settings, touch the [OK] key. 2-98 Contents