Sharp MX-M4070 User Manual - Page 834
SMB Settings, Ping Command, DNS Settings, SMTP Settings
View all Sharp MX-M4070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 834 highlights
SYSTEM SETTINGS►SYSTEM SETTINGS SMB Settings Set the version of SMB protocol that is used for functions such as Scan to Network Folder. Use this setting to connect to a device that cannot automatically change the SMB protocol version, or when there is a problem in the connection with another device due to different versions. Set the version to SMB2.0, SMB2.1, or SMB3.0. • One of the settings is SMB1.0, however, this is always enabled and cannot be disabled. • When a version is disabled, version settings higher than that version are all disabled. When a version is enabled, all version settings lower than that version are enabled. Ping Command Checks if the machine can communicate with the PC of the network. Specify the IP address of the desired PC and tap the [Execute] key. A message indicating a response by the PC or not is displayed. Services Settings Select the general network settings. Select the DNS, SMTP, Kerberos authentication, SNTP, mDNS, SNMP, and WINS settings. DNS DNS Settings IPv4 Settings Primary Server Enter the IP address of primary DNS server. Secondary Server Enter the IP address of secondary DNS server. IPv6 Settings Primary Server Enter the IP address of primary DNS server. Secondary Server Enter the IP address of secondary DNS server. Timeout Enter a timeout. The default setting is 2 seconds. This time is used until the connection to the DNS server is established according to the standard specifications. Domain Name Enter the domain name where the selected DNS server exists. DNS Update Set this option to use the dynamic updating of DNS server. Update Interval Enter an interval to update the DNS server. SMTP SMTP Settings Primary Server Enter the IP address or the host name of the primary SMTP server. Secondary Server Enter the IP address or the host name of the secondary SMTP server. Port Number Enter a port number. The default setting is port 25. 7-80