Sharp PG-M15X PG-M15S , PG-M15X Operation Manual - Page 21
Basic Operations, INPUT, Projector, Remote control, Zooming/Focusing, VOLUME, AV MUTE, ON/OFF, POWER
UPC - 074000358225
View all Sharp PG-M15X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Basic Operations Zooming/Focusing 3 Rotate the ZOOM knob. The image can be adjusted to the desired size within the zoom range. 4 Rotate the FOCUS ring until the image on the screen becomes clear. Operation Projector 8 5 7 6 Remote control EXAMPLE 5 INPUT 1 (DVI) Mode f INPUT 1 (RGB) Mode 6 VOLUME 15 7 8 f INPUT 1 (COMPONENT) Mode 5 Press INPUT to select the desired input mode. Press INPUT again to change the mode. • When the selected input signal is being received, "Adjusting The Image" will be displayed. • When no signal is being received, "NO SIGNAL" will be displayed. When a signal that the projector is not preset to receive is being received, "NOT REG." will be displayed. • You can display all input modes one by one when "Auto Source" is set to "OFF". 6 Press VOLUME on the remote control to adjust the volume. 7 Press AV MUTE on the remote control to temporarily turn off the picture and the sound. Press AV MUTE again to turn the picture and the sound back on. 8 Press ON/OFF on the projector or POWER on the remote control, and then press ON/OFF or POWER again while the message is displayed to turn off the power. • If you accidentally pressed ON/OFF or POWER and do not want to turn off the power, wait until the power off screen disappears. • When ON/OFF or POWER is pressed twice, the POWER indicator illuminates red and the cooling fan will run for about 90 seconds. The projector will then enter standby mode. • Wait until the cooling fan stops before disconnecting the power cord. • The power can be turned on again by pressing ON/OFF or POWER. When the power is turned on, the POWER indicator and the LAMP REPLACEMENT indicator light green. f INPUT 2 (S-VIDEO) Mode f INPUT 3 (VIDEO) Mode 19