Sharp PG-M15X PG-M15S , PG-M15X Operation Manual - Page 6

Important Information IMPORTANT SAFEGUARDS 22. Installation • For best results, use the product in a darkened room. • Place the product on a flat, level surface in a dry area away from dust and moisture. • Do not place the product in direct sunlight, near heaters or heat radiating appliances. • Exposure to direct sunlight, smoke or steam can harm internal components. • Handle the product carefully. Dropping or jarring can damage internal components. • Do not place heavy objects on top of the product. 23. Power Supply • The product is designed to operate on a power supply of 100 to 240 V 50/60 Hz AC. Ensure that your power supply fits these requirements before attempting to use the unit. • For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment and shall be accessible. • Disconnect the power cable (main lead) from the power outlet after using the product. Before disconnecting the power cable, make sure the POWER indicator lamp is orange and not flashing. • Handle the power cable carefully and avoid excessive bending. A damaged cord can cause electric shock or fire. IMPORTANT • DLP (Digital Light Processing) and DMD (Digital Micromirror Device) are trademarks of Texas Instruments, Inc. • Microsoft and Windows are registered trademarks in the United States and other countries of Microsoft Corporation. • PC/AT is a registered trademark in the United States of International Business Machines Corporation. • Macintosh is a registered trademark in the United States and other countries of Apple Computer, Inc. • The other company and product names mentioned are trademarks or registered trademarks of each respective company. 24. Lamp Replacement • Be sure to replace the lamp when the LAMP indicator comes on. If you continue to use the lamp after 1,500 hours of usage, the lamp will turn off (See pages 47 and 48). 25. Fire and Shock Precautions • Ensure that there is sufficient ventilation and that vents are unobstructed to prevent the buildup of heat inside the product. Allow at least 7 7/8 inches (20 cm) of space between the unit and surrounding obstructions. • Prevent foreign objects such as paper clips and bits of paper from falling into the product. Do not attempt to retrieve any objects that fell into the product. Do not insert any metal objects such as a wire or screwdriver into the product. If something should fall into the product, immediately disconnect the power cable from the product and have the object removed by a Sharp Authorized Projector Dealer or Service Center. • Do not place any liquids on top of the product. • Do not look into the lens while the product is on. Serious damage to your eyes could result. 4