Sharp R-CD1800M R-CD1200M , R-CD1800 , R-CD-2200M Operation Manual - Page 14
Operation when Program Lock ON is set
View all Sharp R-CD1800M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
* Suppose you want to set Program Lock ON. Procedure 1 Press the CUSTOM HELP pad x 2 CUSTOM HELP twice within 2 seconds. 3 2 START 2 Enter 3, 2 for Program Lock ON. 3 Press the START pad to save the setting. STOP CLEAR 4 Press the STOP/CLEAR pad to exit from the Custom Help Function. NOTE : If you select Program Lock OFF, the LOCK indicator in the display will disappear when you press the START pad. Operation when Program Lock ON is set KEY Operation Custom Help Title When Program Lock ON is set 1 Selecting Memory Input Method no operation 2 Selecting Auto Start no operation Operation 3 Program Lock Setting operation Audible Signal 4 Sound Volume Setting no operation 5 Cooking Completion no operation Signal Setting 6 Memory Check operation Counter Check/Clear check : operation 7 clear : no operation Air Intake Filter 8 Counter check, clear : operation set : no operation Selecting Operation no operation 9 in case of Magnetron Failure x2/x3 Multiplication Factors for Double/ Triple Quantity check : operation set : no operation EXPRESS Express Defrost DEFROST Setting check : operation set : no operation 4. Audible Signal Sound Volume Setting The volume of the audible signal can be adjusted to High, Medium, or Mute. CH41 : High = Factory Setting CH42 : Medium CH43 : Mute To set cooking completion signal volume Press the CUSTOM HELP pad twice within 2 seconds then enter the numbers 4, 1 for High 4, 2 for Medium 4, 3 for Mute Press the START pad to save setting and the STOP/CLEAR pad to exit from the Custom Help Function. NOTE : Even when errors occur, your oven will not beep in mute setting. 5. Cooking Completion Signal Setting There is a choice of 4 different signals on your oven. CH51 : 1 long beep = Factory setting CH52 : Repeating long beeps CH53 : 4 short beeps CH54 : Repeating short beeps To set the signal type Press the CUSTOM HELP pad twice within 2 seconds then enter the numbers 5, 1 for 1 long beep 5, 2 for repeating long beeps 5, 3 for 4 short beeps 5, 4 for repeating short beeps Press the START pad to save settings and the STOP/ CLEAR pad to exit from the Custom Help Function. 6. Memory Check Use this setting to check the programming for a certain memory. * Suppose you want to know the information programmed into memory 1, programmed for 4 minutes at 60% for the 1st stage and 2 minutes at 30% at the 2nd stage programmed Dual Digit Input. Procedure Display 6 CUSTOM HELP x 2 1 Press the CUSTOM HELP pad twice within 2 seconds and enter 6. NO. CHECK EN-13