Sharp R930CS R-930CS/AK/AW Microwave Operation Manual - Page 5

INSTALLATION INSTRUCTIONS Unpacking and Examining Your Oven Remove: 1. all packing materials from inside the oven cavity. Read enclosures and SAVE the Operation Manual. DO NOT REMOVE AND THROW OUT THE WAVE GUIDE COVER. 2. the feature sticker from the outside of the door, if there is one. Check the oven for any damage, such as misaligned or bent door, damaged door seals and sealing surfaces, broken or loose door hinges and latches and dents inside the cavity or on the door. If there is any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SERVICER. Choosing a Location for Your Oven You will use your oven frequently so plan its location for ease of use. The oven must be placed on a countertop which is a minimum of 36 inches from the floor. Allow at least 2 inches on the sides, top and at the rear of the oven for air circulation. Be sure to position oven so that the rear cannot be touched inadvertently. MIN. 11/2" Your convection microwave oven can be built into a cabinet or wall by itself or above any Electric wall oven or warming drawer using Sharp's Built-in Kit MIN. listed below. It cannot be built in above any gas wall 36" oven. Sharp Convection Microwave Oven Model R-930AK R-930AW R-930CS Applicable Built-in kits RK-66A RK-66WB RK-93S27 RK-93S30 Hinges Latches Oven Cavity Door Seals and Sealing Surfaces MICROWAVE CUTOUT ELECTRIC WALL OVEN/WARMING DRAWER CUTOUT Sketch-1 Note for R-930CS: Select the Built-in kit RK-93S27 or RK-93S30 depending on the desired finished width. The RK-93S27 is for a 27 inch and the RK-93S30 is for a 30 inch finished width. See Sketch 1 for proper location when building in above an electric wall oven or a warming drawer. Carefully follow both the electric wall oven/warming drawer installation instructions and Sharp's Built-in Kit instructions. Be sure that the clearance of the floor between the electric wall oven/warming drawer and the microwave oven is minimum of 11/2 inches. Ordering the Built-in Kits. If your dealer does not stock the kit, it can be ordered directly from the Sharp Accessories and Supplies Center. Have your credit card number available and call toll-free: 1-800-237-4277 for ordering the kit to be sent to your address. The kit includes ducts and finish trim strips and easy-to-follow instructions for installation as well as the location of the power supply. 3