Sharp UP-3301 Instruction Manual - Page 42

Tax Calculations Automatic tax When your POS terminal is programmed with a tax table (or tax rate) and the tax status of an individual department or PLU is set for taxable, it computes the tax automatically on any item that is entered into the department directly or indirectly via a related PLU. ■ Manual tax Your POS terminal allows you to enter tax manually after item entries. ■ Tax deletion You can delete the automatic tax on the taxable 1, taxable 2, taxable 3, or taxable 4 subtotal of each transaction by touching the corresponding TAX SHIFT key followed by the subtotal, then the TAX key after the subtotal is displayed. NOTE If any of the media keys (i.e. cash, check 1 thru check 4, or charge 1 thru charge 8) are programmed for tax delete in the PGM2 mode, the tax can be deleted without using the procedures above. In this case touching a corresponding media key that has been programmed will always cause the selected tax to be deleted. ■ Tax status shift Your POS terminal allows you to shift the programmed tax status of each department, discount, or percent key or of the PLU key by touching the TAX1SF , TAX2SF , TAX3SF , and/or TAX4SF keys before those keys are touched. After each entry is completed, the programmed tax status of each key is resumed. NOTE The entry of a multi-taxable item for PST or GST will be prohibited as follows (for Canada): In case of; Tax 1: PST, Tax 2: PST, Tax 3: PST, Tax 4: GST Taxable 1 and 2 item prohibited Taxable 1 and 3 item prohibited Taxable 2 and 3 item prohibited Taxable 1 and 4 item allowed Taxable 2 and 4 item allowed Taxable 3 and 4 item allowed In case of; Tax 1: PST, Tax 2: PST, Tax 3: GST, TAX 4: GST Taxable 1 and 2 item prohibited Taxable 1 and 3 item allowed Taxable 2 and 3 item allowed Taxable 1 and 4 item allowed Taxable 2 and 4 item allowed Taxable 3 and 4 item prohibited 40 www.cashregisters.net