Sharp UX-500 UX-500 UX-510 Operation Manual - Page 4
Receiving Documents, Loading paper, Installing the imaging film, RECEPTION, START - fax manual
![]() |
View all Sharp UX-500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Quick Reference Guide Receiving Documents Installing the imaging film Press the RECEPTION MODE key until "AUTO" or "MANU" appears in the display. RECEPTION MODE 1. Press the release marked OPEN and open the print compartment cover. AUTO reception: The fax will automatically answer after four rings and receive the incoming document. MANUAL reception: Lift the handset when the fax rings. If you hear a fax tone, wait until RECEIVING appears in the display, then hang up (if RECEIVING doesn't appear, press the START key). If the calling party talks to you, press your START key to begin reception. (See Pages 37-38 of your manual.) Loading paper 1. Insert the paper tray into the fax if not yet installed. 2. Remove the paper cover if it is on the tray. (For legal paper, flip up the tray externder.) 3. Pull the paper release plate toward you. ♦ If any paper remains in the tray, take it out and combine it into a single stack with the new paper. 4. Insert the stack of paper into the tray. Replace the tray cover and then push the paper release LETTER LEGAL plate back down. 5. Press the following sequence of keys: FUNCTION 6 Press "1" if you loaded letter size paper, or "2" if you loaded legal size paper. When finished, press: STOP (See pages 9-10 of your manual.) 2. Insert two of the gears into the ends of the spool with film. 3. Hold the empty spool so that the end with only one slot is on the left, and lower the spools into the printing compartment so that the gears fit into the slots on each side of the compartment. 4. Cut the band holding the spools together with scissors, and remove it. Insert the remaining gear into the right end of the empty spool and the flange into the left end of the empty spool. 5. Pull the empty spool toward the back of the compartment, unwinding the leader from the spool with film. Insert the empty spool into the compartment so that the gear and spool fit into the slots on each side of the compartment. 6. Wind the film slightly to remove slack and then close the printer compartment cover. 7. If you replaced the film, press the following sequence of keys (this is not necessary for the sample film included with the fax): FUNCTION 6 START (See Pages 2-5 of your operation manual.)
![](/manual_guide/products/sharp-ux500-ux500-ux510-operation-manual-c2b5d9c/4.png)