Sharp UX-500 UX-500 UX-510 Operation Manual - Page 98
Messages and Signals, Display messages
View all Sharp UX-500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Chapter 12 Troubleshooting Messages and Signals Display messages CHECK PAPER SIZE COVER OPEN DOCUMENT JAM FAX RX IN MEMORY FILM END FUNCTION MODE LINE ERROR LINE IS IN USE MEMORY IS FULL MEMORY PRINTING ON HOOK DIAL OUT OF PAPER OVER HEAT PAPER JAMMED The paper size setting is incorrect. Change the paper size setting as described in "Loading the Paper" in Chapter 1. The printing compartment cover is open. Close it. The original document is jammed. See the following section, "Clearing Paper Jams". A fax has been received in memory because the imaging film needs replacement, you have run out of printing paper, or the paper is jammed. The fax will print out automatically when the problem is fixed. The imaging film may need replacement. Check the film and replace it if necessary. The FUNCTION key has been pressed. Transmission or reception was not successful. Press STOP to clear the message, and then try again. An extension phone connected to the fax is being used. Do not lift the fax's handset or attempt transmission at this time, as this will interrupt the conversation on the extension phone. The memory is full. See "Memory" in Chapter 8. The fax is preparing to or printing out a document from memory. The SPEAKER key has been pressed and the fax is waiting for you to dial. You are out of printing paper. The print head has overheated. Operation can be continued once it cools. The printing paper is jammed. See the following section, "Clearing Paper Jams". Note: If you have turned on the Caller ID function, see "Caller ID" in Chapter 8 for display messages related to Caller ID. 88