Sharp UX-500 UX-500 UX-510 Operation Manual - Page 88
Printing Reports and Lists, Explanation of headings, Transmission errors - fax telephone line error problem
View all Sharp UX-500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Chapter 10 Printing Reports and Lists Explanation of headings SENDER/ The fax number of the other machine involved in the transaction. If this RECEIVER machine does not have an ID function, the communication mode will appear (for example, "G3"). PAGES Number of pages transmitted or received. NOTE OK - Transmission/reception was normal. P.FAIL - A power failure occurred. JAM - A problem with the fax paper or document occurred. NO PAPER - You ran out of fax paper during reception. CANCEL - Transmission was cancelled because the STOP key was pressed, no document was in the feeder, or the other machine requested transmission using a function which your fax does not have. COM.E-0 to COM.E-14 - A telephone line error prevented the transaction. Explanations of the error numbers are given in the following tables, however, these are primarily for use by service engineers. In general, you will want to simply try the transaction again. If necessary, check with the other party to make sure their machine is functioning properly. Transmission errors E-0 E-1 E-2 E-3 E-4 E-6 E-7 E-8 E-11 E-12 E-13 Able to recognize handshake signal, but it has errors. Cannot recognize the handshake signal from the receiver side. Line disconnected during transmission. Line disconnected after modem speed fall-back. Line disconnected during multi-page transmission. Cannot recognize the handshake signal for next page at receiver side. No response from receiver side or "disconnect signal" is received at transmitter side. Error was not corrected after the predetermined number of retries because of an error in a part of a page. Error occurred after or while reception by the remote (receiving) machine was revealed to be impossible. Error occurred just after fall-back. Error occurred after a response to a retransmission end command was received. 78