Sharp XG C40XU XG-C40XU Operation Manual - Page 18

Connecting the Projector Connecting the Remote Mouse Receiver You can use the remote control as a remote mouse. Setup & Connections Connecting to the USB port on a PC or Macintosh 1 Connect one end of the supplied USB mouse control cable to the corresponding terminal on the computer. 2 Connect the other end to the USB port on the remote mouse receiver. USB mouse control cable QCNWG0007CEPZ USB port Remote mouse receiver RUNTK0673CEZZ Use the USB port (PC or Macintosh) to connect the supplied USB mouse control cable to the remote mouse receiver. Connecting to the PS/2 port on a PC 1 Turn off the power of the PC. 2 Connect one end of the PS/2 mouse control cable to the corresponding terminal on the PC. 3 Connect the other end to the PS/2 port on the remote mouse receiver. 4 Turn on the power of the PC. PS/2 port PS/2 mouse control cable (commercially available) Remote mouse receiver RUNTK0673CEZZ Use the PS/2 port (PC) to connect the PS/2 mouse control cable to the remote mouse receiver. CAUTION • Do not connect or disconnect the mouse control cables to or from the computer while it is on. This may damage your computer. • Do not connect both the PS/2 and USB mouse control cables to the remote mouse receiver. • Windows 95 does not support USB mouse driver software. • The minimum system requirements for the USB type mouse system are shown below. Windows Hardware: PC/AT compatible machine with USB port that has Windows 98/Windows 2000 or higher installed. OS: Windows 98/Windows 2000 or higher Macintosh Hardware: Macintosh series with USB port OS: Mac OS 8.5 or higher • The wireless mouse functions can be used to operate computers compatible with PS/2 or USB type mouse systems. E-17