Sharp XR-10 XG-MB55X Operation Manual - Page 63
Troubleshooting
View all Sharp XR-10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Troubleshooting Problem Check Page • Projector power cord is not plugged into the wall outlet. • Power to the external connected devices is off. • The selected input mode is wrong. • Cables incorrectly connected to the projector. • Remote control battery has run out. No picture and no sound • External output has not been set when connecting notebook or projector does not computer. start. • The lamp unit cover is not installed correctly. • Cables incorrectly connected to the projector. • "Bright" is set to minimum position. • Depending on the computer you are using, an image may not be projected unless the signal output setting of the computer is switched to the external output. Refer to the computer's operation manual for how to switch its signal output settings. Sound is heard but no picture appears (or picture is dark). • Image adjustments are incorrectly set. • Make adjustments of "Color" and "Tint" in "Picture Mode" and lower the "Bright Boost" value. (Video Input only) • Video input system is incorrectly set. 26 - 30 23-26 14 23 51, 52 23-26 40 - 40 46 Color is faded or poor. Picture is blurred; noise appears. • Adjust the focus. 28 • The projection distance exceeds the focus range. 20 (Computer Input only) • Perform "Fine Sync" Adjustments ("Clock" Adjustment) 46 • Perform "Fine Sync" Adjustments ("Phase" Adjustment) 46 • Noise may appear depending on the computer. - • Cables incorrectly connected to the projector. • Volume is set to minimum. • When the projector is connected to an external device and the volume is set to minimum, the sound is not output even if you turn up the volume of the external device. 23-26 30 Picture appears but no • "Speaker" is set to "Off". 43 sound is heard. An unusual sound is • If the picture is normal, the sound is due to cabinet shrinkage - occasionally heard from caused by room temperature changes. This will not affect operation the cabinet. or performance. Maintenance indicator on • See "Maintenance Indicators". 49 the projector illuminates or blinks in red. The projector cannot be • The keylock is set. turned on or put into the If the keylock is set to "ON", all the buttons are locked. 45 standby mode using the STANDBY/ON button on the projector. 59 Appendix