Singer 7469Q Confidence Quilter Instruction Manual - Page 78
Performance Checklist
View all Singer 7469Q Confidence Quilter manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
5. PERFORMANCE CHECKLIST GENERAL PROBLEMS Machine does not sew. * Power switch is turned off.- Turn on the switch. * Buttonhole lever is not raised when sewing stitch patterns. - Raise buttonhole lever. * Buttonhole lever is not lowered when sewing buttonhole. - Lower buttonhole lever. * Bobbin winder is engaged. - Disengage bobbin winder (see page 16 - 17). Machine jams/knocks. * Thread is caught in hook.- Clean hook (see page 72 - 73). * Needle is damaged.- Replace needle (see page 24 - 25). Fabric does not move. * Presser foot is not lowered - Lower presser foot. * Stitch length is too short - Lengthen stitch length. * Feed dogs are lowered - Raise feed dogs. Desired pattern cannot be selected. * Twin needle mode switch has been turned on and lit red. - Turn off the switch. STITCHING PROBLEMS Machine skips stitches. * Needle is not all the way up into needle clamp. - See page 24 - 25. * Needle is bent or blunt. - Replace needle (see page 24 - 25). * Machine is not threaded correctly. - See page 20 - 21. * Thread is caught in hook. - Clean hook (see page 72 - 73). Stitches are irregular. * Needle size is not correct for thread and fabric. - See page 24 - 25. * Machine is not threaded correctly. - See page 20 - 21. * Top thread tension is too loose. - See page 26 - 27. * Fabric is being pulled or pushed against machine feeding action. - Guide it gently. * Bobbin has not been wound evenly. - Rewind bobbin. Needle breaks. * Fabric is being pulled or pushed against machine feeding action. - Guide it gently. * Needle size is not correct for thread and fabric. - See page 24 - 25. * Needle is not all the way up into the needle clamp. - See page 24 - 25. * Twin needle is being used but stitch width is set too wide. - See page 74 - 75. THREAD PROBLEMS Thread bunches. * Top and bobbin threads are not drawn back under presser foot before starting seam. - Draw both threads back under presser foot about 6 inches (10 cm) and hold until a few stitches are formed. Needle thread breaks. * Machine is not threaded correctly. - See page 20 - 21. * Top thread tension is too tight. - See page 26 - 27. * Needle is bent. - Replace needle (see page 24 - 25). * Needle size is not correct for thread and fabric - See page 24 - 25. Bobbin thread breaks. * Bobbin case is not threaded correctly. - See page 18 - 19. * Lint accumulates in bobbin case or hook. - Remove lint (see page 72 - 73). Fabric puckers. * Top thread tension is too tight. - Adjust thread tension (see page 26 - 27). * Stitch length is too long for sheer or soft fabric. - Shorten stitch length. 78