Singer C240 FEATHERWEIGHT Instruction Manual and Troubleshooting Guide - Page 12

Inserting the Bobbin Make sure that the needle is fully raised and the machine 1 is turned off before inserting or removing the bobbin. Open the bobbin cover by pushing the release button to the right (A). Remove the cover (B). 1. Insert the bobbin in the bobbin case with the thread running in a counterclockwise direction. B 2. Pull the thread through the slit (C). 3. With a finger held gently on top of the bobbin, draw the thread at the arrow markings into the stitch plate 3 thread guide from (C) to (D). D 4. Pull the thread at the arrow markings into the stitch plate thread guide from (D) to (E). 5. To cut off excess thread pull thread back over the cutting off blade at point (E). 6. Replace the bobbin cover. Threading the Machine Make sure that the presser foot is raised and the needle is in its highest position. 1. Place the thread on the spool pin and fit the appropriately sized spool cap. 2. Pull the thread into the right thread guide (B) from front to back and the left thread guide (C) from back to front. Pull the thread between the tension discs (D). 3. Thread down through the right-hand threading slot and then upwards through the left-hand threading slot. 4. Bring the thread from the right into the take-up lever (E) and down in the left-hand threading slot, into the lower thread guide (F) and to the needle thread guide (G). 5. Thread the needle. B C 2 A 4 C E E D 12 G F