Snapper S22675 Operater's Manual - Page 11

Mounting the Grass Bag 1. To mount the grass bag on the mower, raise the rear door (A, Figure 8). Remove the mulching plug. Important: The mulching plug should be removed only when bagging is desired, and should be replaced as soon as bagging operations are completed. 2. Holding the grass bag by the handle (A, Figure 9), mount the hooks (B) on either end of the grass bag frame assembly onto the rear door pivot rod (C). Lower the grass bag against the rear of the mower. Lower the rear door. Important: Make sure both grass bag hooks are mounted on the pivot rod. Assembly A B Figure 8: Removing the mulching plug WARNING: Check the condition of the r n grass bag for wear or deterioration. If worn or damaged, replace the parts only with fo tio approved factory replacement parts. ot uc Emptying the Grass Bag N d WARNING: Before you remove the grass o bag, stop the engine. Before you remove r any grass from the mower housing, discon- nect the wire from the spark plug. p 1. Raise the rear door to a vertical position. e 2. Hold the handle of the grass bag and lift the frame R assembly. Continue to lift the frame assembly until B A C the hooks are no longer mounted on the pivot rod. Remove the grass bag. Figure 9: Mounting the grass bag 3. Empty the grass from the grass bag. 4. To mount the grass bag on the mower, see "Mounting The Grass Bag". en 11