Sony BDV-E390 Operating Instructions - Page 37

Other Operations Deactivating the Buttons on the Unit (Child Lock) You can deactivate the buttons on the unit (except for "/1) for preventing misoperation, such as child mischief (child lock function). Press x on the unit for more than 5 seconds. "LOCKED" appears in the front panel display. The child lock function is activated and the buttons on the unit are locked. (You can operate the system by using the remote.) To cancel, press x for more than 5 seconds so that "UNLOCK" appears in the front panel display. • When you operate the buttons on the unit while the child lock function is on, "LOCKED" flashes in the front panel display. Controlling Your TV with the Supplied Remote By adjusting the remote signal, you can control your TV with the supplied remote. • When you replace the batteries of the remote, the code number may reset itself to the default (SONY) setting. Reset the appropriate code number. Preparing the remote for controlling the TV Press and hold TV "/1 while entering your TV's manufacturer's code (see the table) using the number buttons. Then release TV "/1. If the setting is unsuccessful, the currently registered code is not changed. Re-enter the code number. Code numbers of controllable TVs If more than one code number is listed, try entering them one at a time until you find the code that works with your TV. Manufacturer SONY LG PANASONIC SAMSUNG SHARP TOSHIBA VIZIO Code number 01 (default) 02 05 02, 06 03 04 07 Changing the Brightness of the Front Panel Display Press DIMMER. Each time you press DIMMER, the brightness of the front panel display is changed. Saving Power in Standby Mode Check that the following settings are both made: - [Control for HDMI] in [HDMI Settings] is set to [Off] (page 44). - [Quick Start Mode] is set to [Off] (page 44). 37US