Sony BKM-FW31 Operating Instructions - Page 24

Operations from a Computer Controlling the Display from a Computer You can perform various adjustments and settings of the Display on a computer's display. Check that this device is firmly installed in the Display and that this device, the personal computer, and the router or hubs are connected via LAN cables. Then turn on the display, the computer, and the router or hubs. Four control windows are available; Information, Configuration, Control, and Setup, each with distinct functions. For details on the buttons, see the Operating Instructions of the FWD series as well. 1 Start the computer's browser (Internet Explorer 6.0 or later). 2 Type "http://xxx.xxx.xxx.xxx (for the IP address of this device)" and press the ENTER key of the keyboard. You can confirm the IP address of this device using the information menu of the Display unit. 3 Click the function tab to select the window you want. Information window This window displays information about the Display unit, such as the Model name, Serial No., and the current operating status of the Display unit, including the presence of power and an input signal. This window only displays information. You cannot change settings using this window. Configuration window Timer Sets the timer. After setting the timer, click Apply. Screen Saver Sets the screen saver. After setting the desired screen saver, click Apply. Picture and Picture Sets the Picture and Picture mode. After setting the desired mode, click Apply. NOTE Refer to the Operating Instructions for the FWD series for details on each function as well. Depending on the Display model, some functions are not supported. Control window POWER (power switch) Turns the power of the Display unit on or off. INPUT (input selector) Switches the input signal. PICTURE MODE (picture mode) Switches the picture mode. ASPECT (aspect) Switches the width of the screen display. GB10 Operations from a Computer