Sony BKM-FW32 Operating Instructions - Page 23
Choose Obtain an IP address, When you need to set an IP address, manually
View all Sony BKM-FW32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
If the network environment is changed, you must set up a new IP address again. • When using this device in a DHCP envirnment; Disconnect the LAN cable once, and then connect it again. An IP address is automatically obtained. • When the IP address has been set manually; Modify the settings in accordance with the new network environment. NOTE When you need to set an IP address manually When an IP address cannot be set automatically, follow the steps below to set an IP address manually. 1 Connect this device and the computer directly using a crossover LAN cable. 2 Choose "Obtain an IP address automatically" on the computer. 3 Turn on the power of the Display unit in which this device is installed. 4 After about 30 seconds, confirm the IP address assigned to this device using the menu screen of the Display unit. 5 Access the IP address confirmed in Step 4 using your browser. NOTE When you cannot access the network • Set the browser of the computer to access the Internet without using a proxy server. • If the IP address of the computer is not 169.254.xxx.xxx or the subnet mask is not 255.255.0.0, change the settings to those address values. 6 Set the IP address manually on this device following the steps given on page 11 (GB). 7 Disconnect the crossover LAN cable, then connect this device to a network in which fixed IP addresses are used, using a straight LAN cable. NOTE If you misconfigure the connection, press and hold the RESET button for more than 3 seconds to clear the settings. Then repeat the procedure from Step1. Preparations for Using the Networking Function 9GB