Sony BTA-NW1A Operating Instructions - Page 12

Registering Bluetooth devices Up to 16 Bluetooth devices can be registered with this unit. When registering devices, consult the operating instructions supplied with the Bluetooth device. When you try to register the 17th device, you must clear all of the previous registrations. 3, 7 12-GB 1, 4, 6, 9 (1) Before registering, be sure to set the POWER ON/OFF switch to OFF. (2) Remove the battery cover. (3) Set the BONDING/NORMAL switch to BONDING. (4) Set the POWER ON/OFF switch to ON. The POWER lamp (green) lights up, and the lamp (blue) lights up. (5) Turn on the Bluetooth device, then input the serial number (pass key) which is indicated on the label on the rear of the unit. For details on inputting this information, refer to the operating instructions of the Bluetooth device. ® MODEL NO. BTA-NW1A MODEM ADAPTOR WITH BLUETOOTHTM FUNCTION Pass key The number used when registering a Bluetooth device zTip The pass key is an identification number needed to allow two Bluetooth devices to communicate with each other. This "Pass key" is also referred to as a "Bluetooth pass key," "pass key," "PIN," "Bluetooth PIN," etc. (6) Set the POWER ON/OFF switch to OFF. (7) Set the BONDING/NORMAL switch to NORMAL. Note Be sure to set it to NORMAL. If you use the unit with the switch in the BONDING position, the communication will be picked up by other devices. (8) Replace the cover. (9) Set the POWER ON/OFF switch to ON. The registration is completed.