Sony CDP-CX335 Operating Instructions - Page 33
Specifications, Troubleshooting - dimensions
View all Sony CDP-CX335 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Additional Information Troubleshooting If you experience any of the following difficulties while using the player, use this troubleshooting guide to help you remedy the problem. Should any problem persist, consult your nearest Sony dealer. There is no sound. /Check that the player is connected securely. /Make sure you operate the amplifier correctly. The CD does not play. /There is no CD in a slot ("-NO DISC-" appears). Insert a CD. /Insert the CD with the label side facing right. /Clean the CD (see page 32). /Moisture has condensed inside the player. Open the front cover and leave the player turned on for about an hour (see page 32). The remote does not function. /Remove obstacles in the path of the remote and the player. /Point the remote at the remote sensor g on the player. /Replace all the batteries in the remote with new ones if they are weak. /Set the CD 1/2/3 switch on the remote according to the position of the COMMAND MODE selector displayed in the front panel display (see page 5). The player functions incorrectly. /The microcomputer chips may be operating incorrectly. Disconnect the AC power cord, then connect it back to the wall outlet to reset the player. Specifications Compact disc player Laser Semiconductor laser (λ = 780 nm) Emission duration: continuous Laser output Max 44.6 µW* * This output is the value measured at a distance of 200 mm from the objective lens surface on the Optical Pick-up block with 7 mm aperture. Frequency response 20 Hz to 20 kHz ±0.5 dB Signal-to-noise ratio More than 107 dB Dynamic range More than 93 dB Harmonic distortion Less than 0.0045 % Channel separation More than 100 dB Outputs Jack Maximum Load impedance type output level ANALOG OUT Phono jacks 2 V Over 10 kilohms (at 50 kilohms) DIGITAL OUT Optical -18 dBm (OPTICAL) output connector Wave length: 660 nm General Power requirements Power consumption Dimensions (approx.) (w/h/d) Mass (approx.) 120 V AC, 60 Hz 13 W 430 × 189 × 484 mm (17 × 7 1/2 × 19 1/8 in.) incl. projecting parts 8.5 kg (18 lbs 12 oz) Supplied accessories See page 4. Design and specifications are subject to change without notice. 33