Home » Sony Manuals » Automotive Audio & Video » Sony CDX-GT705DX » Manual Viewer

Sony CDX-GT705DX Operating Instructions - Page 19

Maintenance, Removing the unit, Replacing the lithium battery of the, card remote commander - installation

Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

For details on ATRAC CD, see the SonicStage or SonicStage Simple Burner manual. Note Be sure to create the ATRAC CD using authorized software, such as SonicStage 2.0 or later, or SonicStage Simple Burner 1.0 or 1.1. If you have any questions or problems concerning your unit that are not covered in this manual, consult your nearest Sony dealer. Cleaning the connectors The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 4) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged. Maintenance Replacing the lithium battery of the card remote commander Under normal conditions, the battery will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.) When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. Use of any other battery may present a risk of fire or explosion. + side up 2c 1 Notes on the lithium battery • Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. • Wipe the battery with a dry cloth to assure a good contact. • Be sure to observe the correct polarity when installing the battery. • Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur. WARNING Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire. Main unit Back of the front panel Notes • For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch. • Never touch the connectors directly with your fingers or with any metal device. Removing the unit 1 Remove the protection collar. 1 Detach the front panel (page 4). 2 Engage the release keys together with the protection collar. Orient the release keys as shown. 3 Pull out the release keys to remove the protection collar. Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. Fuse (10A) continue to next page t 19

Section	Page
GB	2
Getting Started	4
Resetting the unit	4
Setting the clock	4
Detaching the front panel	4
Attaching the front panel	5
Inserting the disc in the unit	5
Ejecting the disc	5
Location of controls and basic operations	6
Main unit	6
Card remote commander RM-X152	6
CD	8
Display items	8
Repeat and shuffle play	8
Radio	8
Storing and receiving stations	8
Storing automatically - BTM	8
Storing manually	8
Receiving the stored stations	8
Tuning automatically	9
Receiving a station through a list - LIST	9
Enjoying your best sound- X-DSP	9
HDEQ	9
DSO 3D	10
Intelligent Time Alignment - I-TA	10
BBE MP	10
Setting X-DSP easily	10
Setting the equalizer - HDEQ	10
Setting DSO 3D and I-TA	11
Setting BBE MP	11
Optimizing your sound - Sound MENU	11
HDEQ Tuning	11
DSO 3D Tuning	12
I-TA Tuning	12
Precisely adjusting your sound	13
Other functions	14
Changing the sound settings	14
Adjusting the sound characteristics - Balance/Fader/ Sub Woofer	14
Adjusting menu items - MENU	14
Using optional equipment	15
CD/MD changer	15
Auxiliary audio equipment	16
Rotary commander RM-X4S	16
Additional Information	17
Precautions	17
Notes on discs	17
About MP3/WMA files	18
About ATRAC CD	18
Maintenance	19
Removing the unit	19
Specifications	20
Troubleshooting	21
Error displays/Messages	22
The conversion table	23
FR	24
Préparation	26
Réinitialisation de l’appareil	26
Réglage de l’horloge	26
Retrait de la façade	26
Installation de la façade	27
Insertion du disque dans le lecteur	27
Éjection du disque	27
Emplacement des commandes et opérations de base	28
Appareil principal	28
Mini-télécommande RM-X152	28
CD	30
Rubriques d’affichage	30
Lecture répétée et lecture aléatoire	30
Radio	31
Mémorisation et réception des stations	31
Mémorisation automatique - BTM	31
Mémorisation manuelle	31
Réception des stations mémorisées	31
Recherche automatique des fréquences	31
Réception d’une station par l’intermédiaire d’une liste - LIST	31
Pour bénéficier d’un son optimal - X-DSP	32
HDEQ	32
DSO 3D	32
Synchronisation intelligente - I-TA	32
BBE MP	33
Réglage facile du X-DSP	33
Réglage de l’égaliseur - HDEQ	33
Réglage des fonctions DSO 3D et I-TA	33
Réglage de la fonction BBE MP	33
Optimisation du son à votre convenance - MENU Sound	33
Syntonisation de HDEQ	34
Syntonisation de DSO 3D	34
Syntonisation de I-TA	35
Réglage précis du son à votre convenance	36
Autres fonctions	37
Changement des réglages du son	37
Réglage des caractéristiques du son - Balance/Fader/Sub Woofer	37
Réglage des paramètres de menu - MENU	37
Utilisation d’un équipement en option	39
Changeur CD/MD	39
Appareil audio auxiliaire	40
Satellite de commande RM-X4S	40
Informations complémentaires	41
Précautions	41
Remarques sur les disques	41
À propos des fichiers MP3/WMA	41
À propos des CD ATRAC	42
Entretien	42
Démontage de l’appareil	43
Caractéristiques techniques	44
Dépannage	44
Affichage des erreurs et messages	46
Tableau de conversion	47
ES	48
Procedimientos iniciales	50
Restauración de la unidad	50
Ajuste del reloj	50
Extracción del panel frontal	50
Colocación del panel frontal	51
Inserción del disco en la unidad	51
Expulsión del disco	51
Ubicación de los controles y operaciones básicas	52
Unidad principal	52
Control remoto de tarjeta RM-X152	52
CD	54
Elementos de la pantalla	54
Reproducción repetida y aleatoria	54
Radio	55
Almacenamiento y recepción de emisoras	55
Almacenamiento automático - BTM	55
Almacenamiento manual	55
Recepción de las emisoras almacenadas	55
Sintonización automática	55
Sintonización de una emisora mediante una lista - LIST	55
Disfrute del mejor sonido - X-DSP	56
HDEQ	56
DSO 3D	56
Alineación de tiempo inteligent - I-TA	57
BBE MP	57
Ajuste sencillo de X-DSP	57
Ajuste del ecualizador - HDEQ	57
Ajuste de DSO 3D e I-TA	57
Ajuste de BBE MP	57
Optimización del sonido - MENU Sound	57
Sintonización HDEQ	58
Sintonización DSO 3D	58
Sintonización I-TA	58
Ajuste preciso del sonido	60
Otras funciones	61
Cambio de los ajustes de sonido	61
Ajuste de las características del sonido - Balance/Fader/Sub Woofer	61
Ajuste de elementos de menú - MENU	61
Uso de un equipo opcional	63
Cambiador de CD/MD	63
Equipo auxiliar de audio	64
Mando rotatorio RM-X4S	64
Información complementaria	65
Precauciones	65
Notas sobre los discos	65
Acerca de los archivos MP3/WMA	65
Acerca de los CD de ATRAC	66
Mantenimiento	66
Extracción de la unidad	67
Especificaciones	68
Solución de problemas	68
Mensajes/indicaciones de error	70

Match case Limit results 1 per page

For details on ATRAC CD, see the SonicStage or

SonicStage Simple Burner manual.

Note

Be sure to create the ATRAC CD using authorized

software, such as SonicStage 2.0 or later, or

SonicStage Simple Burner 1.0 or 1.1.

If you have any questions or problems concerning

your unit that are not covered in this manual, consult

your nearest Sony dealer.

Maintenance

Replacing the lithium battery of the

card remote commander

Under normal conditions, the battery will last

approximately 1 year. (The service life may be

shorter, depending on the conditions of use.)

When the battery becomes weak, the range of the

card remote commander becomes shorter. Replace

the battery with a new CR2025 lithium battery. Use

of any other battery may present a risk of fire or

explosion.

Notes on the lithium battery

•

Keep the lithium battery out of the reach of children.

Should the battery be swallowed, immediately

consult a doctor.

•

Wipe the battery with a dry cloth to assure a good

contact.

•

Be sure to observe the correct polarity when

installing the battery.

•

Do not hold the battery with metallic tweezers,

otherwise a short-circuit may occur.

Fuse replacement

When replacing the fuse, be

sure to use one matching the

amperage rating stated on the

original fuse. If the fuse blows,

check the power connection and

replace the fuse. If the fuse

blows again after replacement,

there may be an internal

malfunction. In such a case,

consult your nearest Sony

dealer.

Cleaning the connectors

The unit may not function properly if the connectors

between the unit and the front panel are not clean. In

order to prevent this, detach the front panel (page 4)

and clean the connectors with a cotton swab dipped

in alcohol. Do not apply too much force. Otherwise,

the connectors may be damaged.

Notes

•

For safety, turn off the ignition before cleaning the

connectors, and remove the key from the ignition

switch.

•

Never touch the connectors directly with your fingers

or with any metal device.

Removing the unit

Remove the protection collar.

Detach the front panel (page 4).

Engage the release keys together with the

protection collar.

Pull out the release keys to remove the

protection collar.

+ side up

WARNING

Battery may explode if mistreated.

Do not recharge, disassemble, or dispose of

in fire.

Fuse (10A)

continue to next page

Main unit

Back of the front

panel

Orient the release

keys as shown.