Sony CMT-EX200 Operating Instructions - Page 12
Programing CD tracks — Program Play, Other Operations
View all Sony CMT-EX200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Playing a CD (continued) Other Operations To Stop play Pause Select a track Find a point in a track Remove a CD Play repeatedly (Repeat Play) Do this Press x. Press NX (or X on the remote). Press again to resume play. Press . or > repeatedly until you find the desired track. Keep pressing m or M during play and release it at the desired point. Touch OPEN/CLOSE Z (or press OPEN/CLOSE Z on the remote). Press REPEAT on the remote during play until "REP" or "REP 1" appears. REP: For all the tracks on the CD. REP 1*: For a single track only. To cancel playing repeatedly, press REPEAT on the remote until "REP" or "REP 1" disappears. * You cannot repeat only one track during Shuffle Play and Program Play. Tip If you press a number button on the remote, the track corresponding to the pressed number on the disc starts playing (Track Direct Play). To enter track number 10 or over on the remote 1 Press >10. 2 Enter the corresponding number buttons. To enter 0, press 10/0 instead. Example: To enter track number 30, press >10, then 3 and 10/0. Notes • Do not forcibly press the disc down with your finger, as this may cause CD player trouble. Furthermore, do not obstruct the ejecting CD. Be sure to touch OPEN/CLOSE Z (or press OPEN/ CLOSE Z on the remote) to lower the disc tray. • The disc tray will not operate if you touch OPEN/ CLOSE Z while wearing gloves. Touch OPEN/ CLOSE Z with bare hands or press OPEN/ CLOSE Z on the remote. Programing CD tracks - Program Play You can make a program of up to 24 tracks. 1 Press FUNCTION repeatedly to switch the function to CD. 2 Press PLAY MODE on the remote repeatedly until "PGM" appears. 3 Press . or > repeatedly until the desired track number appears. Playing time of the selected track Track number 4 Press ENTER on the remote. The track is programed. The total playing time of the program and the number of the last programed track are displayed. 5 To program additional tracks, repeat steps 3 and 4. 6 Press NX (or CD N on the remote). Other Operations To Cancel Program Play Clear the entire program Select the desired track using number buttons Do this Press PLAY MODE on the remote repeatedly until "PGM" and "SHUF" disappear. Press x in stop mode. Press number buttons on the remote instead of performing steps 3 to 5. Tips • The program you made remains after Program Play finishes. To play the same program again, press NX (or CD N on the remote). • When the total playing time has exceeded 100 minutes, the time is not displayed and the total number of programed tracks is displayed. 12