Sony CMT-LS1 Operating Instructions - Page 8
Replacing the battery in the, remote, Step 1, Hooking up the system, continued
View all Sony CMT-LS1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Step 1: Hooking up the system (continued) 6 Connect the L cord to the SPEAKER jack as shown below. 7 Attach the speaker with the L cord to the left side as viewed from the front of the unit. Replacing the battery in the remote 1 Slide out and remove the battery case. 2 Insert a new lithium battery CR2025 with the + side facing up. a lithium battery CR2025 Battery life You can expect the remote to operate for about 6 months (using a Sony CR2025 lithium battery) before the battery run down. When the battery no longer operates the remote, replace the battery with a new one. To avoid battery leakage If you are not going to use the remote for a long time, remove the battery to avoid damage caused by corrosion from battery leakage. Notes on lithium battery • Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. • Wipe the battery with a dry cloth to assure a good contact. • Be sure to observe the correct polarity when installing the battery. • Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur. • Do not break up the battery or throw it into a fire, which might cause it to explode. Carefully dispose of the used battery. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommend by the manufacturer. Discard used batteries according to the manufacturer's instructions. WARNING Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire. 3 Slide the battery case back in. 8