Sony DCR-SR65 Operating Guide - Page 29

Troubleshooting Troubleshooting If you run into any problems using your camcorder, use the following table to troubleshoot the problem. If the problem persists, disconnect the power source and contact your Sony dealer. Notes before sending your camcorder for repair  Your camcorder may require initializing or change the current hard disk of the camcorder, depending on the problem. In the event of this, the data stored on the hard disk will be deleted. Be sure to save the data on the internal hard disk (see "Handycam Handbook" (PDF)) on other media (backup) before sending your camcorder for repair. We will not compensate you for any loss of hard disk data.  During repair, we may check a minimum amount of data stored on the hard disk in order to investigate the problem. However, your Sony dealer will neither copy nor retain your data.  For the symptoms of your camcorder, see "Handycam Handbook" (PDF) and for connecting to the computer, see "PMB Guide." The power does not turn on.  Attach a charged battery pack to the camcorder (p. 9).  Connect the plug of the AC Adaptor to the wall outlet (wall socket) (p. 9). The camcorder does not operate even when the power is set to on.  It takes a few seconds for your camcorder to be ready to shoot after the power is turned on. This is not a malfunction.  Disconnect the AC Adaptor from the wall outlet (wall socket) or remove the battery pack, then reconnect it after about 1 minute. If the functions still do not work, press the RESET button (p. 18) using a sharp-pointed object. (If you press the RESET button, all settings, including the clock setting, are reset.)  The temperature of your camcorder is extremely high. Turn off your camcorder and leave it for a while in a cool place.  The temperature of your camcorder is extremely low. Turn off the camcorder and take it to a warm place. Leave the camcorder there for a while, then turn on the camcorder. Your camcorder gets warm.  This is because the power has been turned on for a long time. This is not a malfunction. The power abruptly turns off.  Use the AC Adaptor.  Turn on the power again.  Charge the battery pack (p. 9). Pressing START/STOP or PHOTO does not record images.  Set the POWER switch to (Movie) or (Still) (p. 12).  You cannot record images in sleep mode. Press the QUICK ON button (p. 19).  Your camcorder is recording the image you have just shot on the media. You cannot make new recording during this period.  The media of the camcorder is full. Delete unnecessary images (p. 25).  Total number of movies or still images exceeds the recordable capacity of the media. Delete unnecessary images (p. 25). The recording stops.  The temperature of your camcorder is extremely high/low. Turn off your camcorder and leave it for a while in a cool/warm place. You cannot install "Picture Motion Browser."  Check the computer environment required to install "Picture Motion Browser."  Install "Picture Motion Browser" in an orderly manner (p. 26). US 29 Troubleshooting