Sony DCRPC330 Computer Applications Guide - Page 14

Connecting with the USB cable (supplied) When connecting your camcorder to your computer with the USB cable (supplied), you must have the proper USB driver installed on your computer (p. 8) before following the steps below. 3 Touch [P-MENU], [MENU] and [USB- CAMERA], then touch to select [USB STREAM]. For details on using the personal menu, refer to the separate Camera Operations Guide supplied with your camcorder. 4 Connect the USB cable (supplied) to the USB jack on the camcorder. to USB jack USB cable (supplied) to USB jack b Note • Do not connect your camcorder to the computer at this point. 1 Start up the computer. Close down all applications running on the computer. For Windows 2000/Windows XP Log on as Administrators. 2 Prepare the power source for your camcorder, then slide the POWER switch to select the CAMERA-TAPE mode. Use the supplied AC Adaptor as the power source. For details, refer to the separate Camera Operations Guide supplied with your camcorder. Fully insert. The location of the USB jack varies depending on the model. Refer to the separate Camera Operations Guide supplied with your camcorder for the location. For the model that is supplied with the Handycam Station, connect the USB cable to the USB jack on the Handycam Station, then set the USB ON/OFF switch to ON. 5 Connect the other end of the USB cable to the USB jack on your computer. It may take some time for the computer to recognize the camcorder when you connect the USB cable for the first time. For Windows XP If [Found New Hardware Wizard] appears, click [Continue Anyway] and complete the installation. 6 Turn off the power of your camcorder. 7 Disconnect the USB cable from your camcorder. 8 Insert a recorded "Memory Stick" into your camcorder. 14 Connecting to a Windows computer