Sony DSR 45A Operating Instructions - Page 49
Connections for a Cut Editing System
UPC - 027242689602
View all Sony DSR 45A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Connections for a Cut Editing System The following figure shows a cut editing system configuration that uses this unit as the player. For details of connecting devices other than the DSR-45/ 45P, refer to the instruction manual of each device. Note The preroll time of the setting on the editing controller is required to be more than five seconds. S VIDEO OUT 5 VIDEO OUT 1 COMPONENT OUT 1 DSR-45/45P (player) MONITOR VIDEO 3 MONITOR AUDIO 3 Video input Audio input S VIDEO IN VIDEO IN Y, R-Y, B-Y IN Source video monitor Chapter 3 Using the Unit as a Player in an Editing System VIDEO IN REF.IN AUDIO OUT CH-4 4 AUDIO OUT CH-3 4 AUDIO IN CH-4 AUDIO IN CH-3 AUDIO OUT CH-2 4 AUDIO IN CH-2 1 AUDIO OUT CH-1 4 AUDIO IN CH-1 2 RS-422A Recorder REF.VIDEO OUT Reference video signal generator REF.VIDEO OUT 1 REF.VIDEO OUT 1 REF.VIDEO IN MONITOR AUDIO 3 Audio input MONITOR REMOTE VIDEO OUT 1 Video input PLAYER REF.VIDEO IN Main video monitor Editing controller RECORDER 2 1 75 Ω coaxial cable (not supplied) 2 9-pin remote control cable (not supplied) Connect one of the following as a video cable: video cable (3BNC y 3BNC), S-video cable, or 75 Ω coaxial cable. Note Use a recorder equipped with a synchronization function. 3 Phono jack cable (not supplied) 4 Cable with XLR connectors (not supplied) 5 S-video cable (not supplied) 49 Chapter 3 Using the Unit as a Player in an Editing System (GB)