Sony FWDS42H1 Operating Instructions - Page 54

Recommendations on Installation Provide an ample amount of space around the display • To prevent internal heat buildup from sealing off the display, make sure to ensure proper ventilation by leaving open the minimum amount of space around the display, as illustrated below. • The ambient temperature must be 0 °C to 35 °C (32 °F to 95 °F). Be careful when installing the display near a ceiling. The temperature there can become much higher than the normal, lower-level room temperature. • When using the stand, you use the applicable Tabletop Stand SU-S01 (not supplied).For the fitting method, see the instruction manual of the Tabletop Stand. • Regarding the installation of hardware such as brackets, screws, or bolts, we cannot specify the products. Actual installation is up to the authorized local dealers. Consult with qualified Sony personnel for installation. • While the display is on, a certain amount of heat builds up inside. This can cause burns. Avoid touching the top or rear of the display when it is powered on or just after it has entered standby mode. When using the Tabletop Stand Front 25 (9 7/8) 10 10 (4) (4) Side 10 (4) When mounting the display horizontally Front 25 (9 7/8) 10 10 (4) (4) Side 25 (9 7/8) 5 (2) Units: cm (inches) When mounting the display vertically Front 20 (7 7/8) Make sure that the 1 (POWER) switch is at the lower left. 25 (9 7/8) Side 25 (9 7/8) 10 (4) 5 (2) Units: cm (inches) Note When moving or installing the display when it is attached to the stand (not supplied), do so with at least 2 people. 8 GB Units: cm (inches)