Sony GT630UI Owners Guide - Page 22

- General Outputs: Audio outputs tenninal (front/rear) Subwoofer output tenninal (mono) Power antenna (aerial) relay control tenninal Power amplifier control tenninal Inputs: Remote controller input tenninal Antenna (aerial) input tenninal Telephone ATT control tenninal Illumination control tenninal BUS control input tenninal BUS audio input tenninal AUX input jack (stereo mini jack) USB signal input tenninal Tone controls: Low: ±1O dB at 60 Hz (XPLOD) Mid: ± 10 dB at 1 kHz (XPLOD) High: ±1O dB at 10 kHz (XPLOD) Power requirements: 12 V DC car battery (negative ground (earth» Power supply voltage: II - 16 V Dimensions: Approx. 178 x 50 x 182 mm (7 1/8 x 2 x 7 1/4 in) (w/h/d) Mounting dimensions: Approx. 182 x 53 x 162 mm (71/4 x 2 1/8 x 6 112 in) (w/h/d) Mass: Approx. 1.3 kg (2 Ib 14 oz) Supplied accessories: Card remote commander: RM-X151 Parts for installation and connections (I set) Optional accessories/equipment: Rotary commander: RM-X4S BUS cable (supplied with an RCA pin cord): RC-61 (1 m), RC-62 (2 m) CD changer (10 discs): CDX-757MX CD changer (6 discs): CDX-T69 Source selector: XA-C40 AUX-IN selector: XA-300 USB connection cable for iPod: RC-l00lP HD RadioTM tuner: XT-lOOHD Your dealer may not handle some of the above listed accessories. Please ask the dealer for detailed information. Design and specifications are subject to change without notice. • Halogenated flame retardants are not used in the certain printed wiring boards. • Halogenated flame retardants are not used in cabinets. • Packaging cushions are made from paper. Troubleshooting The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. If the problem is not solved, visit the following support site. Support site http://esupport.sony.com http://www.sony.com/xplod No power is being supplied to the unit. • Check the connection or fuse. ·If the unit is turned off and the display disappears, it cannot be operated with the remote commander. - Tum on the unit. The power antenna (aerial) does not extend. The power antenna (aerial) does not have a relay box. No sound. • The ATT function is activated, or the Telephone ATT function (when the interface cable of a car telephone is connected to the ATT lead) is activated. • The position of the fader control "FAD" is not set for a 2-speaker system. No beep sound. • The beep sound is canceled (page 16). • An optional power amplifier is connected and you are not using the built-in amplifier. The contents of the memory have been erased. • The RESET button has been pressed. - Store again into the memory. • The power supply lead or battery has been disconnected or it is not connected properly. Stored stations and correct time are erased. The fuse has blown. Makes noise when the position of the ignition is switched. The leads are not matched correctly with the car's accessory power connector. During playback or reception, demonstration mode starts. If no operation is perfonned for 5 minutes with "DEMO-ON" set, demonstration mode starts. -Set "DEMO-OFF" (page 16). The display disappears from/does not appear In the display window. • The dimmer is set "DIM-ON" (page 17). • The display disappears if you press and hold (OFF). --+ Press and hold (OFF) on the unit until the display appears. • The connectors are dirty (page 21). 22