Sony GVM-2000 Operating Instructions - Page 5

• RGB V HOLD (vertical hold) control When the picture from the RGB input rolls vertically, turn this control to stabilize it. W RGB H SHIFT (horizontal shift) control Turn to adjust the horizontal position of the RGB input picture, if it is off center. Turn it clockwise to shift the picture toward the right and counterclockwise to shift the picture toward the left. Note If this control is not set to the center detent position, the picture may disappear from the display or good color may not be obtained on some input sources. Be sure to display the picture with the control set to the center detent position, and then adjust the horizontal position. • RGB H/V SIZE (horizontal/vertical size) controls Turn the H-SIZE control to adjust the horizontal size. Turn the V-SIZE control to adjust the vertical size. • RGB sub picture control Adjust this control if the picture level of RGB inputs differs significantly from that of video inputs. Turn this control clockwise to make the contrast and color intensity of the RGB input picture stronger, or counterclockwise to make them weaker. Note Controls El to function only for RGB input pictures. El V HOLD (vertical hold) control If the video input picture rolls vertically, use this control to stabilize it. M Picture adjustment controls SHARP (sharpness) control Normally keep this control at the center detent position. Turn it clockwise to obtain a sharper picture or counterclockwise to obtain a softer picture. BRIGHT (brightness) control Normally keep this control at the center detent position. Turn it clockwise to make the picture brighter or counterclockwise to make it darker. COLOR control Turn this control clockwise to make the picture more vivid or counterclockwise to make it paler. HUE control Use this control to obtain the most natural skin tones. Turn it clockwise to add green to the skin tones or counterclockwise to add purple/red hues. M Response lamp Blinks when the VOL or PICTURE buttons are pressed. Lights steadily at the highest or lowest volume or picture level. El PICTURE UP/DOWN buttons Press the UP button to make the contrast and color intensity stronger or press the DOWN button to make them weaker. Note Controls II and W do not function for RGB input pictures. El VOL UP/DOWN buttons Press the UP button for more volume or press the DOWN button for less volume. to Input select buttons Press to select the input source to be monitored. LINE A: for input signals fed through the LINE A connectors LINE B: for input signals fed through the LINE B connectors RGB A: for input signals fed through the RGB A connector and the RGB A AUDIO jack RGB B: for input signals fed through the RGB B connectors and the RGB B AUDIO jack El Input select indicators LINE A/LINE B/RGB A/RGB B When the input source is selected, the corresponding indicator lights. LI STANDBY indicator Lights when the power is turned off by remote control through control S signal. g POWER switch Depress to turn on the monitor. Press again to turn it off. 5