Sony HCD-HP7 Operating Instructions - Page 22

Display, Turning off the display, — Power Saving Mode

Page 22 highlights

Other operations To Check the setting Change the setting Cancel the timer Do this 1 Press CLOCK/TIMER SELECT. 2 Press ./> repeatedly until "REC SELECT" appears, then press ENTER. Start over from step 1. 1 Press CLOCK/TIMER SELECT. 2 Press ./> repeatedly until "TIMER OFF" appears, then press ENTER. Notes • You cannot activate the Daily Timer and recording timer at the same time. • If you use the recording timer and the Sleep Timer at the same time, the Sleep Timer has priority. • If the system is on at the preset time, the timer recording will not be activated. • The volume is reduced to minimum during recording. Display Turning off the display - Power Saving Mode The demonstration display (display window and buttons lighting and flashing even when the system power is off) and the clock display can be turned off to minimize the amount of power consumed during standby (Power Saving Mode). Press DISPLAY repeatedly while the system is off until the demonstration display or the clock display disappears. To cancel Power Saving Mode Press DISPLAY repeatedly while the system is off. Each time you press the button, the display switches cyclically as follows: Demonstration display t Clock display* t No display (Power Saving Mode) * The clock is displayed only if you set the clock. Note You cannot perform the following operations in Power Saving Mode. - setting the clock - changing the AM tuning interval (except for European, Russian, Middle Eastern and Philippine models) - turning on the system by pressing the function buttons Tip The timer continues to operate in Power Saving Mode. 22GB

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

22
GB
Other operations
Notes
You cannot activate the Daily Timer and recording
timer at the same time.
If you use the recording timer and the Sleep Timer at
the same time, the Sleep Timer has priority.
If the system is on at the preset time, the timer
recording will not be activated.
The volume is reduced to minimum during
recording.
The demonstration display (display window and
buttons lighting and flashing even when the
system power is off) and the clock display can
be turned off to minimize the amount of power
consumed during standby (Power Saving
Mode).
Press DISPLAY repeatedly while the
system is off until the demonstration
display or the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY repeatedly while the system is
off. Each time you press the button, the display
switches cyclically as follows:
Demonstration display
t
Clock display*
t
No display (Power Saving Mode)
* The clock is displayed only if you set the clock.
Note
You cannot perform the following operations in Power
Saving Mode.
– setting the clock
– changing the AM tuning interval (except for
European, Russian, Middle Eastern and Philippine
models)
– turning on the system by pressing the function
buttons
Tip
The timer continues to operate in Power Saving Mode.
To
Do this
Check the setting
1
Press CLOCK/TIMER
SELECT.
2
Press
./>
repeatedly
until “REC SELECT”
appears, then press ENTER.
Change the setting
Start over from step 1.
Cancel the timer
1
Press CLOCK/TIMER
SELECT.
2
Press
./>
repeatedly
until “TIMER OFF” appears,
then press ENTER.
Display
Turning off the display
— Power Saving Mode