Sony HDR-CX300 Handycam® Handbook - Page 48
Setting the GPS function, triangulates successfully, it will record
UPC - 027242788817
View all Sony HDR-CX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Setting the GPS function Set the GPS switch to ON ( appears on the LCD screen). Your camcorder starts trying to triangulate. When your camcorder triangulates successfully, it will record the location information at the time movies and photos were recorded. Notes Use the GPS function in outdoors. The camcorder may not be able to receive radio signals in places where radio signals are blocked or reflected, such as indoors or a place surrounded by buildings or trees. The indicator changes according to the strength of GPS signal reception. Triangulating status GPS indicators GPS reception status Function off No indicator The GPS switch is set to OFF, or the GPS receiver is not functioning normally. Unable to triangulate Processing Your camcorder cannot find a GPS signal, therefore, it cannot triangulate. Move to an open area and turn on the GPS switch again. Your camcorder is searching for a GPS satellite signal. It may take several minutes to complete the triangulation. Triangulating Triangulating Your camcorder is receiving a GPS signal, and can acquire location information. Your camcorder is receiving a strong GPS signal, and can acquire location information. US 48 The GPS switch is set to ON in the default setting. Movies and photos will be recorded with location information. When your camcorder cannot acquire the location information, the last acquired location information is recorded. If you do not want to record location information, set the GPS switch to OFF. If the camcorder cannot track a satellite even after waiting for several minutes, you are in a difficult place to receive a GPS signal. Start recording in the current state or move to a place that is easier receive radio signals. Even if the camcorder is turned off, the GPS function is working as long as the GPS switch is set to ON. Make sure that the GPS switch is set to OFF during takeoff and landing of an airplane. The dots in the lower right of show GPS signal quantity. When fewer than 3 dots are displayed, the GPS signal is not stable enough to triangulate in the current environment. Move to an open area first, and turn the GPS switch to OFF and ON again, or turn the power of your camcorder off and on. When search of satellite signal is unsuccessful after a few minutes of searching, your camcorder quits searching for a satellite signal. If your camcorder continues to display (triangulation process not started) even after moved to an open area, turn the GPS switch to OFF and ON again, or turn the power of your camcorder off and on. Processing time can be shortened when you load the GPS assist data into the camcorder using the supplied software "PMB." Install "PMB" on your computer and connect the computer to the internet. Then connect the camcorder to the computer and the GPS assist data will be automatically updated. The GPS assist data may not function in the following cases: When the GPS assist data are not updated for about 30 days or more When the date and time of the camcorder are not correctly set When the camcorder is moved for a long distance.