Sony HVR-DR60 Operating Instructions - Page 22

Trouble shooting, Power sources, Recording - problems

Page 22 highlights

Trouble shooting Please check the following before contacting your Sony dealer. Note in case of repairs • Some kinds of repair work may require that the hard disk be formatted or replaced. In either case, all data on the hard disk will de deleted. Back-up your data from the hard disk before sending it for repairs. Sony does not guarantee against data being deleted during repair work. • During repair work, Sony may perform a minimal check of the data on a hard disk in order to verify improvements or the occurrence of defective symptoms. However, Sony never copies or saves the data. Power sources Symptom The camcorder gets warm. The remaining battery time indicator does not indicate the correct time. The battery pack discharges too quickly. Cause/Remedy • This unit may get warmer while you use it. This is not a malfunction. • The ambient temperature is too high or too low, or the battery pack has not been charged enough. This is not a malfunction. t Fully charge the battery pack again. If the problem persists, the battery pack may be worn out. Replace it with a new one (p. 8). • The indicated time may not be correct in certain circumstances. • The ambient temperature is too high or too low, or the battery pack has not been charged enough. This is not a malfunction. t Fully charge the battery pack again. If the problem persists, the battery pack may be worn out. Replace it with a new one (p. 8). Recording Symptom Sliding the REC switch does not record images. Cause/Remedy • The POWER switch is set to COMPUTER. t Slide the POWER switch to VIDEO (p. 6). • This unit is recording the image you have just shot. t Leave this unit for a while and then slide the REC switch. • This unit is full. t Delete unrequired images. t Format this unit by selecting DELETE and then FORMAT. • The temperature of this unit is extremely high. t Turn off this unit and leave it for a while in a cool place. • The temperature of this unit is extremely low. t Leave this unit for a while with the POWER switch turned on. If you still cannot operate this unit, turn it off and move it to a warm place. Leave this unit there for a while and then turn it back on. • The folder number shows 999 and the file number shows 9999. t Delete unrequired images (p. 11) or format this unit by selecting DELETE and then FORMAT. • You may be unable to record images during drop detection. 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30

22
Symptom
Cause/Remedy
Sliding the REC switch does not
record images.
Trouble shooting
Please check the following before contacting your Sony dealer.
Note in case of repairs
• Some kinds of repair work may require that the hard disk be formatted or replaced. In either case, all data on the hard disk
will de deleted. Back-up your data from the hard disk before sending it for repairs. Sony does not guarantee against data
being deleted during repair work.
• During repair work, Sony may perform a minimal check of the data on a hard disk in order to verify improvements or the
occurrence of defective symptoms. However, Sony never copies or saves the data.
Power sources
Symptom
Cause/Remedy
The camcorder gets warm.
The remaining battery time indicator
does not indicate the correct time.
The battery pack discharges too
quickly.
Recording
• The POWER switch is set to COMPUTER.
t
Slide the POWER switch to VIDEO (p. 6).
• This unit is recording the image you have just shot.
t
Leave this unit for a while and then slide the REC switch.
• This unit is full.
t
Delete unrequired images.
t
Format this unit by selecting DELETE and then FORMAT.
• The temperature of this unit is extremely high.
t
Turn off this unit and leave it for a while in a cool place.
• The temperature of this unit is extremely low.
t
Leave this unit for a while with the POWER switch turned on. If you still
cannot operate this unit, turn it off and move it to a warm place. Leave this
unit there for a while and then turn it back on.
• The folder number shows 999 and the file number shows 9999.
t
Delete unrequired images (p. 11) or format this unit by selecting DELETE and
then FORMAT.
• You may be unable to record images during drop detection.
• This unit may get warmer while you use it. This is not a malfunction.
• The ambient temperature is too high or too low, or the battery pack has not been
charged enough. This is not a malfunction.
t
Fully charge the battery pack again. If the problem persists, the battery pack
may be worn out. Replace it with a new one (p. 8).
• The indicated time may not be correct in certain circumstances.
• The ambient temperature is too high or too low, or the battery pack has not been
charged enough. This is not a malfunction.
t
Fully charge the battery pack again. If the problem persists, the battery pack
may be worn out. Replace it with a new one (p. 8).