Sony ICD-P520 Operating Instructions - Page 43

Connecting the IC recorder to your computer You can transfer the IC recorder data onto your computer by connecting the IC recorder to the computer. Use the USB connecting cable supplied with the IC recorder to connect the USB connectors of the IC recorder and your computer. The IC recorder is recognized by the computer as soon as the cable is connected. You can connect or disconnect the cable when the IC recorder and the computer are turned on or off. To USB connector of IC recorder Connecting cable (supplied) To USB connector of your computer  Notes  Be sure to install the Digital Voice Editor software before connecting the IC recorder to your computer. Otherwise, a message like [Found New Hardware Wizard] may appear when you connect the IC recorder to your computer. In this case, click [Cancel].  Do not connect more than two USB devices to your computer. Normal operation will not be guaranteed.  Use of this IC recorder with a USB hub or a USB extension cable is not guaranteed.  A malfunction may occur depending on the USB devices connected at any one time.  Before connecting the IC recorder to the computer, check that batteries are inserted in the IC recorder.  When you connect the IC recorder to the computer, make sure that the IC recorder is in the stop mode.  It is recommend that you disconnect the cable from the computer when you do not use the Digital Voice Editor. Using the IC Recorder with Your Computer 43GB