Sony KLV-23M1 Operating Instructions - Page 26
Connecting a VCR and Cable TV
View all Sony KLV-23M1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Connecting a VCR and Cable TV Use this hookup if: • You subscribe to a cable TV system that does not require a cable box. Disconnect all power sources before making any connections. 1 Connect the CATV cable to the VCR's IN jack. 2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack to the TV's VHF/UHF jack. 3 Using A/V and S VIDEO cables, connect the VCR's AUDIO and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO 1 IN or VIDEO 2 IN). Tip If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. VHF/UHF 1 S VIDEO VCR 75-ohm coaxial cable (supplied) Cable S VIDEO cable (not supplied) 75-ohm coaxial cable (supplied) S VIDEO VIDEO (yellow) AUDIO-L (white) Rear of TV VIDEO IN VIDEO L AUDIO R (MONO) AUDIO-R (red) A/V cable (not supplied) Note When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure "Auto YC" in the (Setup) menu is set to "On" to view the S VIDEO input (see below). When connecting both VIDEO IN and S VIDEO IN Using the menu, you can select the jack from which the TV receives the input signal. You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN) separately. The TV is factory set to receive S VIDEO input signals. 1 Press VIDEO 1/2 repeatedly until the desired video input appears. 2 Press MENU. 3 Press V/v to select (Setup), then press . 4 Press V/v to select "Auto YC," then press . 5 To watch the pictures input from the S VIDEO input jack: Press V/v to select "On," then press . To watch the pictures input from the VIDEO input jack: Press V/v to select "Off," then press . 6 Press MENU to exit the menu screen. 26