Sony KLV-S20G10 Operating Instructions - Page 21
Satellite Receiver and Cable/Antenna, To connect a satellite receiver
View all Sony KLV-S20G10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Connecting the TV Connecting the TV Satellite Receiver and Cable/Antenna z If you connect the Digital Satellite Receiver with component video cables, see page 23. KLV-S15G10 Satellite Receiver This scenario shows a SAT Box connected through the video inputs and the Cable/Antenna connected through the VHF/UHF input. Satellite signals are selected by the SAT Box through the video inputs while TV signal is selected by the TV tuner. To connect a satellite receiver 1 Connect the satellite antenna cable to the satellite receiver's satellite input jack. 2 Use A/V and S VIDEO cables to connect the satellite receiver's AUDIO and S VIDEO output jacks to the TV's AUDIO and S VIDEO input jacks (VIDEO 1 IN). 3 Connect the supplied 75-ohm coaxial cable from the antenna to the TV's VHF/UHF input jack. 4 Run the Initial Setup program, as described in "Setting Up the Channel List" on page 31. If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. Satellite antenna cable Rear of TV VIDEO 3 IN (480p/480i) PR VIDEO 1 IN R AUDIO OUT PB R AUDIO L R S VIDEO Y AUDIO L (MONO) L VIDEO VHF/UHF S VIDEO cable S VIDEO A/V cable AUDIO-R (red) AUDIO-L (white) VIDEO (yellow) 75-ohm coaxial cable (Continued) 21