Sony KV-32CX10 Primary User Manual - Page 21
Specifications, Troubleshooting
View all Sony KV-32CX10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Specifications Troubleshooting Television system American TV standard Channel coverage VHF: 2-13 UHF: 14-69 Cable TV: 1-125 Picture tube Microblack Trinitron tube 32-inch picture measured diagonally 34-inch picture tube measured diagonally Input VIDEO INPUT 1, 2 and 3 (phono jacks) Video: 1 Vp-p, 75-ohms unbalanced, sync negative Audio: 500 mVrms (100% modulation) Impedance: 47 kilohms S VIDEO INPUT (4-pin mini DIN) Y: 1 Vp-p, 75-ohms unbalanced, sync negative C: 0.286 Vp-p (Burst signal) 75-ohms Output MONITOR OUTPUT (phono jacks) Video: 1 Vp-p, 75-ohms unbalanced, sync negative Audio: 500 mVrms (100% modulation) Impedance: 10 kilohms AUDIO OUTPUT (VARIABLE) (phono jacks) More than 408 mVrms at the maximum volume setting (variable) (100% modulation) Impedance: 10 kilohms Power requirements 120 V AC, 60 Hz Power consumption 185W (max.) - 1W (in standby condition) Accessories supplied Remote Commander RM-755 with 2 size AA batteries Antenna connector Optional accessories U/V mixer EAC-66 Connecting cord VMC-810S/820S RK-74A Design and specifications subject to change without notice. 22 Disturbances in picture and sound can often be eliminated by checking the symptoms and following the suggestions listed below. SYMPTOM Poor or no picture (screen not lit), good sound Good picture, no sound No picture (screen not lit), no sound -J No color W Z 0 Snow and noise only CHECK AND ADJUST • Adjust PICTURE. • Adjust BRIGHT. • Check antenna/cable connections. • Press VOLUME +. • Release MUTING on the Remote Commander. • Check that the MTS button is set correctly. • Check that the TV/VIDEO button or mode select button is set correctly. • Set the SPEAKER switch to ON. • Is POWER switched on? Power in outlet? • Check that the TV/ VIDEO button is set correctly. • Is it a color program? • Adjust COLOR. • Is it an active or the correct channel? • Check the CABLE selector setting. • Check antenna/cable connections. • Check that the ANT/AUX button is set correctly. - ) Dotted This is often caused by 4 1, lines local interference. (e.g. or cars, neon signs, hairdryers stripes etc.) Adjust antenna for minimum interference. Double images or ghosts Reflections from nearby mountains or buildings often cause this problem. A highly directional outdoor antenna or a CATV cable may improve the picture. Try another channel. It could be station trouble. TIMERIBLOCK Program start TIMER and/or channel BLOCK does not operate properly. • Is the clock set correctly? • Is the setting correct? • Have you unplugged the unit? Has a power failure occurred? If so, the settings have been erased. If the problem persists, contact your nearest service facility.