Sony LF-B20 Operating Instructions - Page 15

Setup and Connections Connecting the IR Blaster Attach the supplied IR Blaster to the device connected to the Base Station. You can control the device with the LocationFree device's on-screen remote control via the IR Blaster. Rear of Base Station When operating two devices with the IR Blaster, set the devices and the IR Blaster as shown. IR Blaster to IR BLASTER port IR BLASTER 1 2 You can connect the IR Blaster to either port. LAN S VIDEO OUT IN OUT IN 1 VIDEO L AUDIO R VIDEO L AUDIO R IN 2 DC IN 12V VIDEO L AUDIO R IR Blaster Infrared transmitter Remote sensor With reference to the operating instructions of the device, make sure to place the IR Blaster just above or below the remote sensor. Remote sensors on Sony Recorders and other products are identified with the symbol. Note Do not remove the backing paper from the IR Blaster yet. After configuring LocationFree Player remote control settings (1 "Configuring the LocationFree Player" in "Part 2: LocationFree Player"), remove the backing paper from the IR Blaster and fix it in place. Remote sensors If the infrared receivers on the two devices do not line up like the illustration above, you need to purchase an optional IR Blaster (VM-50, not supplied) and install it. Note For details on setting up a device, refer to the operating instructions of the device. z Tips • If the IR Blaster cable is too short, use the 3.5 mm jack extension cable (not supplied). • Remote sensors on Sony Recorders and other products are identified with the symbol. • You can set up two on-screen remote controls for each video input connector. These on-screen remote controls allow you to operate two devices connected directly to the Base Station, and to control video input via those devices. For more details, refer to "Setting up the on-screen remote control" of "Configuring the LocationFree Player" in "Part 2: LocationFree Player". 15